Cabling A Hard Drive - HP ML330 - ProLiant - G3 Setup And Installation Manual

5. Install the drive tray:
a. Slide the drive tray into the removable media bay.
b. Secure the drive tray with a screw on each side.
6. Connect the data and power cables to the back of all devices. For specific cabling
information, refer to "Cabling a Hard Drive" in this chapter.
7. Install the access panel and the front bezel.

Cabling a Hard Drive

SCSI Cabling
Observe the following guidelines when adding SCSI devices to the server:
•
As a general rule, a maximum of seven devices may be added per channel. The
server is equipped with one integrated Wide Ultra3 SCSI channel.
•
Be sure to remove all terminating jumpers from third-party SCSI devices.
•
You must manually set the SCSI ID on each device to a unique value in the range
of 0 through 6 for each SCSI bus. Refer to the documentation provided with the
device for instructions on how to set the SCSI ID.
HP ProLiant ML330 Generation 3 Server Setup and Installation Guide
Hardware Options Installation
4-15