HP ML330 - ProLiant - G3 Setup And Installation Manual page 64

6. Slide the tape drive into the removable media bay.
7. Connect the end of the existing ATA cable to the IDE (ATAPI) connector on the
system board. For the IDE connector location, refer to Chapter 1, "Component
Identification."
8. Connect the cable connector labeled Device 1 to the tape drive.
9. Connect the cable connector labeled Device 0 to the CD-ROM drive.
10. Connect the next available power cable connector to the hard drive.
11. Install the access panel and the front bezel. Refer to Chapter 2, "Server
Operations."
HP ProLiant ML330 Generation 3 Server Setup and Installation Guide
Hardware Options Installation
4-21