HP ML330 - ProLiant - G3 Setup And Installation Manual page 60

3. Connect the next available SCSI cable connector to the hard drive or SCSI
device.
4. Connect the next available power cable connector to the hard drive or SCSI
device.
ATA Cabling
Observe the following guidelines when adding ATA hard drives to the server:
•
A maximum of two hard drives may be added per channel. The server is
equipped with two integrated ATA/100 RAID channels.
•
Jumpers on ATA devices should be set to Cable Select (CS), enabling primary
and secondary devices to be determined by the cable.
•
Connect ATA hard drives only to the Integrated ATA/100 RAID controller
channels. Do not connect other peripherals to the Integrated ATA/100 RAID
controller channels.
To cable an ATA hard drive:
1. Complete the hardware installation procedure.
2. Connect the end of the ATA cable to the system board.
HP ProLiant ML330 Generation 3 Server Setup and Installation Guide
Hardware Options Installation
4-17