6000 W Power Supply Specifications - Cisco 6509 - Catalyst Chassis Switch Installation Manual

6000 W AC-Input Power Supply

6000 W Power Supply Specifications

Table A-19
Table A-19 6000 W AC-Input Power Supply Specifications
Specification
AC-input type
AC-input voltage
AC-input current
kVA rating
AC-input frequency
Power supply output capacity
Catalyst 6500 Series Switches Installation Guide
A-44
lists the specifications for the 6000 W AC-input power supply.
Appendix A
Description
2 AC-inputs per power supply. High-line input with
power factor correction (PFC) included.
Power factor correction is a standard feature on
Note
all Catalyst 6500 series AC-input power
supplies. PFC reduces the reactive component
in the source AC current allowing higher power
factors (typically 99 percent or better) and
lower harmonic current components.
100 to 120 VAC, single-phase (low line)
•
• 200 to 240 VAC, single-phase (high line)
16 A each input
7.5 kVA
50/60 Hz (nominal) (±3% for full range)
The 6000 W power supply can operate at either
2900 W or 6000 W depending on the number of AC
power cords attached and the source AC voltage:
• 2900 W maximum with the following source AC
arrangements:
– INPUT 1 and INPUT 2 both connected to
110 VAC
INPUT 1 connected to 220 VAC; INPUT 2
–
not connected
– INPUT 1 not connected; INPUT 2 connected
to 220 VAC
INPUT 1 connected to 220 VAC; INPUT 2
–
connected to 110 VAC
INPUT 1 connected to 110 VAC; INPUT 2
–
connected to 220 VAC
1
6000 W maximum with the following source AC
•
arrangements:
INPUT 1 and INPUT 2 both connected to
–
220 VAC
The 6000 W power supply will not power up if
Note
you have only one power cord plugged into
either INPUT 1 or INPUT 2 and source AC is
110 VAC.
Power Supply Specifications
OL-5781-04