Installing The Cable Management System (Catalyst 6509-Neb-A Switch Only) - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Installing the Cable Management System (Catalyst 6509-NEB-A Switch Only)

Installing the Cable Management System (Catalyst 6509-NEB-A
Switch Only)
This section describes the installation procedures for the Catalyst 6509-NEB-A switch cable
management system (CABLETRAY-09).
The cable management system is shipped with the extended cable guide installed but can be used with
Note
the supplied standard cable guide. Use the extended cable guide with Ethernet and Fast Ethernet modules
(24 to 48 ports) using 10/100 cable. Use the standard cable guide with low port-density modules (up to
16 ports) using fiber and coax cable. We recommend that you install the cable management system
before replacing the cable guide. See the
replacement procedures.
To install the cable management system, perform these steps:
Place the cable management system against the chassis, as shown in
Step 1
installation screws.
Assure that the hinge is flat against the chassis, and install four 6x32 screws to secure the back plate to
Step 2
the chassis.
Figure 3-11 Installing the Cable Management System
Note
Catalyst 6500 Series Switches Installation Guide
3-18
Captive installation screws
FAN
STATU S
FAN
1
FAN
2
Hinge screws
To route the cables through the cable guide, remove the front panel, and attach the interface
cables to the modules. See the
information on attaching the interface cables.
"Replacing the Cable Guide" section on page 3-20
"Attaching the Interface Cables" section on page 3-28
Chapter 3 Installing the Switch
for
Figure 3-11, and tighten the captive
OL-5781-04
for