Required Tools; Removing The Ac-Input Pem - Cisco 6509 - Catalyst Chassis Switch Installation Manual

Removing and Installing the Power Entry Modules (PEMs)
Figure 4-41 Catalyst 6503 Switch—Power Supply Location
Power supply 2
Power supply 1

Required Tools

Use a flat-blade or number 2 Phillips-head screwdriver to perform these procedures. Additionally, wire
cutters may be necessary to cut cable tie-wraps.

Removing the AC-Input PEM

Follow these steps to remove an AC-input PEM:
Turn the power switch to the Off (0) position on the PEM that you are removing. (See
Step 1
Disconnect the power cord from the power source. Do not touch the metal prongs on the power cord
Step 2
when it is still connected to the PEM.
Remove the power cord from the power connection on the PEM. Do not touch the metal prongs
Step 3
embedded in the PEM.
Loosen the captive installation screws. (See
Step 4
Grasp the PEM with one hand, and slide it part of the way out of the chassis. Place your other hand
Step 5
underneath the PEM, as shown in
If the PEM bay is to remain empty, install a blank PEM filler plate (Cisco part number 800-16719-01)
Step 6
over the opening, and secure it with the captive installation screws.
Catalyst 6500 Series Switches Installation Guide
4-52
(redundant)
Figure 4-42.)
Figure 4-43, and slide it completely out of the chassis.
Chapter 4 Removal and Replacement Procedures
Figure 4-40.)
OL-5781-04