Table of Contents
Advertisement
S7
Range:
Default:
Units:
This register sets the time, in seconds, that the modem must wait before hanging up
because carrier is not detected. The timer is started when the modem finishes dialing
(originate), or goes off-hook (answer). In originate mode, the timer is reset upon
detection of an answer tone if allowed by country restriction. The timer also specifies
the wait for silence time for the @ dial modifier in seconds. S7 is not associated with
the W dial modifier.
S8
Range:
Default:
Units:
This register sets the time, in seconds, that the modem must pause when it encoun-
ters a comma (",") in the dial command string.
S10
Range:
Default:
Units:
This register sets the length of time, in tenths of a second, that the modem waits
before hanging up after a loss of carrier. This allows for a temporary carrier loss
without causing the local modem to disconnect. The actual interval the modem waits
before disconnecting is the value in register S10.
S11
Range:
Default:
Units:
This register determines the dialing speed which is prefixed for each country.
S12
Range:
Default:
Units:
This register sets the value (in 20 ms increments) for the required pause after the
escape sequence (default 1s).
Connection Completion Time-Out
1-255
50
seconds
Comma Dial Modifier Time
0-65
2
seconds
Automatic Disconnect Delay
1-254
20
0.1 seconds
DTMF Dialing Speed
50-150
95
0.001 seconds
Escape Guard Time
0-255
50
0.02 seconds
69
Advertisement
Table of Contents
