E-2 Installing a New Battery
Installation Procedures
The battery that came with the workstation is permanently installed on the
system board. If the original battery becomes inoperative, you must install a
second battery.
To install the replacement battery, follow these steps:
1. If the workstation is on, turn it off, then unplug the power cord from
2. Remove the side access panel and the expansion board assembly.
3. Remove and discard the protective covering on the adhesive on the
4. Plug the battery connector onto pins 1-4 on the system board.
Figure E-1. Attaching the replacement battery
WARNING: The system board contains a lithium battery. The
lithium battery may explode if mistreated. The battery is soldered
in place and may not be removed. Do not abuse or disassemble.
Use only replacement batteries supplied by Compaq.
the grounded AC electrical outlet.
hook and loop fastener on the back of the battery and attach the battery
to the side of the power supply.