Compaq AP500 - Professional - 128 MB RAM Reference Manual page 29

Using Computer Setup
To use Computer Setup, select Computer Setup from the Compaq Utilities
menu. The following table describes the features available in Computer Setup.
Task
View the product name, processor
type/speed/stepping, CPU serial number,
system ROM date, system board revision,
installed memory size, and asset tracking
number
Set the system time and date
Set the Asset Tag. For more information, see
section "Security Management" in Chapter 3.
Set the POST mode (QuickBoot or FullBoot)
and enable/disable POST messages
Set ISA back-to-back I/O (fast/legacy) delay
and bus priority (ISA/PCI)
View the currently installed drive A:
(preinstalled diskette drive) and drive B:
devices and set resources for diskette drives
Enable/disable diskette booting and diskette
writing
NOTE: After saving changes to Removable
Media, the workstation will restart. Turn the
workstation off, then on, manually.
Table 2-1
Computer Setup Features
Click Built-in Devices, then click System
Information.
Click Built-in Devices, then click System
Information. Click Date/Time.
Click Built-in Devices, then click System
Information. Under System Parameters,
enter the new Asset Tag.
Click Built-in Devices, then click System
Information. Select the appropriate
options under Quick Boot and POST
Messages Descriptive/Clean Mode.
Click Built-in Devices, then click System
Information. Under System Parameters,
select the appropriate I/O Delay.
Click Built-in Devices, then click Storage.
The information is displayed under
Diskette.
Click Built-in Devices, then click Storage.
Select the appropriate option under
Removable Media.
Compaq Professional Workstation AP500 Reference Guide
Computer Setup Selection
2-3
Continued