Compaq AP500 - Professional - 128 MB RAM Reference Manual page 103

Solving Network Problems
Problem
Diagnostics reports a
failure.
Continued
Possible Cause
Possible resource conflict
with another expansion
board.
The cable is not securely
connected.
The cable is attached to the
incorrect connector.
There is a problem with the
cable or a device at the other
end of the cable.
The network controller is
defective.
Network controller interrupt
overlaps the interrupt of an
expansion board.
Compaq Professional Workstation AP500 Reference Guide
Possible Solution
Factory default is 300h to
30Fh for Ethernet. Either
remove and reconfigure
the conflicting expansion
board, or reconfigure the
network controller. If the
address is changed,
ensure that the drive
parameters match the
new I/O address for the
network controller.
Ensure that the cable is
securely attached to the
network connector and
that the other end of the
cable is securely
attached to the correct
device.
Ensure that the cable is
attached to the correct
connector.
Ensure that the cable
and device at the other
end are operating
correctly.
Contact your Compaq
authorized service
provider.
Run the Setup utility and
modify the network
controller memory value.
Continued
11-11