Compaq AP500 - Professional - 128 MB RAM Reference Manual page 72

8-2 Drives
As shown in Figure 8-1, drive bays 1 through 3 are located in the removable
hard drive cage, which is located behind the side access panel of the
workstation. Drive bays 4 through 7 are located on the front of the
workstation. They support various drive configurations.
Ref.
1
2
3
4
5
6
7
8
Drive Bay Components
Component
Bay 1 Part of the removable hard drive cage. A 3.5-inch, third-height
bay that supports a 1.0-inch hard drive or a 1.6-inch hard drive.
Bay 2 Part of the removable hard drive cage. A 3.5-inch, third-height
bay that supports a 1.0-inch hard drive. Bay 2 is not available
when a 1.6-inch drive is installed in bay 1 or bay 3.
Bay 3 Part of the removable hard drive cage. A 3.5-inch, third-height
bay that supports a 1.0-inch hard drive or 1.6-inch hard drive.
Bay 4 5.25-inch, half-height bay that supports 1.0-inch or 1.6-inch
storage devices. A CD-ROM drive is shipped in bay 4.
Bay 5 5.25-inch, half-height bay that supports 1.0-inch or a
1.6-inch storage devices. An optional hard drive, diskette
drive, CD-ROM drive, or tape drive can be installed in bay 5.
Bay 6 5.25-inch, half-height bay that supports 1.0-inch or 1.6-inch
devices. An optional hard drive, diskette drive, CD-ROM drive,
or tape drive can be installed in bay 6.
Bay 7 3.5-inch, third-height bay that supports a 1.0-inch device. A
standard 3.5-inch diskette drive is shipped in bay 7.
Air plenum Side of air plenum provides temporary storage for the
(cooling hardware screws used to install optional mass storage devices
chamber) in the removable hard drive cage and in the front bays.
Table 8-1
Description