Installing An Agp Card; Removing The Agp Card; Figure 17. Installing The Agp Card - Intel S875WP1 - EATX MBD 875 P4 DDR-2CH SATA RAID VID GETH Product Manual

Installing an AGP Card

Follow these instructions to install an AGP card:
1. Observe the precautions in "Before You Begin" on page 39.
2. Place the card in the AGP connector.
3. Press down on the card until it is fully seated in the AGP connector. A retention notch on the
card will snap into place around the retention pin on the lever that is marked "A" in the figure
below.
4. Secure the card's metal bracket to the chassis back panel with a screw.

Removing the AGP Card

Follow these instructions to remove the AGP card from the server board:
1. Observe the precautions in "Before You Begin" on page 39.
2. Remove the screw that secures the card's metal bracket to the chassis back panel.
3. Pull back on the retention mechanism lever (marked "A" in the figure above to release the
retention pin from the notch in the card.
4. Pull straight up on the card to pull it from the socket.
52

Figure 17. Installing the AGP Card

A
TP00191
Intel Server Board S875WP1-E Product Guide