Installing The Server Board; Placing The Server Board Into The Chassis; Attaching The Server Board; Figure 9. Placing The Server Board Into The Chassis - Intel S875WP1 - EATX MBD 875 P4 DDR-2CH SATA RAID VID GETH Product Manual

Installing the Server Board

Placing the Server Board into the Chassis

When placing the board into the chassis, insert the rear I/O connector end first, carefully
positioning the board's I/O connectors into the openings in the I/O shield on the back of the chassis.

Attaching the Server Board

NOTES
You will need a Phillips (#2 bit) screwdriver.
Refer to Page 107 for regulatory requirements and installation instructions
and precautions.
The Intel® Server Chassis SC5200 and the Intel Server Chassis SC5250-E use
different screws to attach the server board to the chassis. Be sure to use the
appropriate screw for your chassis. See the diagram below for the correct
screw for each chassis.
WARNING
Only qualified technical personnel should attempt this procedure. Disconnect
the server from its power source before performing the procedures described
here. Failure to disconnect the power before you open the server can result in
personal injury or equipment damage.
44

Figure 9. Placing the Server Board into the Chassis

TP00103
Intel Server Board S875WP1-E Product Guide