Lexmark Pro4000c User Manual page 11

About your printer
Use the
2 ADF input tray
3 PictBridge and USB port Connect a PictBridge-enabled digital camera or a flash drive to the printer.
4 Card reader light
5 Memory card slot
6 Ink cartridge access
door
7 Paper tray
8 Exit bin
9 Bin extender
10 Printer control panel
Use the
11 Customer support
label
12 Scanner glass
13 Power supply with port Connect the printer to the power cord.
14 Duplex unit
To
Load original documents into the ADF.
Notes:
•
Do not load postcards, photos, small items, or thin media (such as magazine
clippings) into the ADF. Place these items on the scanner glass.
• After scanning, copying, or faxing, you can lift the right end of the input tray to
retrieve the original documents easily.
Check the card reader status. The light comes on when a memory card is inserted and blinks
when a memory card is being accessed.
Insert a memory card.
Install, remove, or replace ink cartridges.
Load paper.
Hold paper as it exits.
Note: For the printer to be ready for any print job, make sure to fully extend the exit bin
and to flip out the bin extender.
Catch the paper as it exits.
Note: For the printer to be ready for any print job, make sure to fully extend the exit bin
and to flip out the bin extender.
Operate the printer.
18
17
16
15
To
Identify the model number of the printer, the customer support hot line, and the ink
cartridge information.
Scan, copy, or fax photos and documents.
• Print on both sides of a sheet of paper.
•
Access paper jams.
12
13
14
SD/M S/xD
/MM C
11
11