Attaching The Lens Cover; Cleaning The Projection Lens; Cleaning The Projector Cabinet - Sanyo PLC-WL2503 Owner's Manual

Maintenance and Cleaning

Attaching the Lens Cover

When moving the projector or while it is not in use, replace
the lens cover.
1
Thread the string through the hole on the lens cover
and then pull at it in the string to secure it in place.
2
To pass the other end of the string into the hole on the
bottom of the projector, thread the lens cover through
the string and then pull at it.

Cleaning the Projection Lens

Unplug the AC power cord before cleaning.
Gently wipe the projection lens with a cleaning cloth that
contains a small amount of non-abrasive camera lens
cleaner, or use a lens cleaning paper or commercially
available air blower to clean the lens.
Avoid using an excessive amount of cleaner. Abrasive
cleaners, solvents, or other harsh chemicals might scratch
the surface of the lens.

Cleaning the Projector Cabinet

Unplug the AC power cord before cleaning.
Gently wipe the projector body with a soft dry cleaning cloth.
When the cabinet is heavily soiled, use a small amount of
mild detergent and finish with a soft dry cleaning cloth. Avoid
using an excessive amount of cleaner. Abrasive cleaners,
solvents, or other harsh chemicals might scratch the surface
of the cabinet.
When the projector is not in use, put the projector in
an appropriate carrying case to protect it from dust and
scratches.
CAUTION
Do not use any flammable solvents or air sprays
on the projector and in its vicinity. The explosion
or fire hazard may occur even after the AC power
cord is unplugged because the temperature inside
the projector is extremely high due to the lamps. In
addition, there is a risk that the internal parts may
be damaged not only by the flammable air spray but
also by the cold air.
62