Optional Parts; The Terminal Panel Replacement - Sanyo PLC-WL2503 Owner's Manual

Appendix
The parts listed below are optionally available. When ordering those parts, specify the item name and Model No. to the sales
dealer.
SCART-VGA Cable
COMPONENT-VGA Cable
VGA-Cable (10 m)
TERMINAL COVER
It is recommended to attach the terminal cover to hide the unsightly cables when hanging the
projector from the ceiling. The optional terminal cover set (including Terminal Cover, Terminal Cover
Attachment and two (2) Screws) is sold separately. Please contact sales dealer where you purchased
the projector.
1
Remove the five (5) screws and pull out
the terminal panel. (Fig.1)
2
Attach the terminal cover attachment
and make sure that it is set properly and
secure the five (5) screws. (Fig 2)
3
Connect the cables from the peripheral
equipment to the projector.
4
Push in the terminal cover and secure the
two (2) screws. (Fig 3)
Note: Make sure to secure the screws to
prevent the terminal cover from falling off.
CAUTION
Do not touch or remove any parts except
for the terminal panel and the five (5)
screws. It may result in malfunctions,
electrical shock, fire hazard or other
accidents.
74

Optional Parts

Model No.
: POA-CA-SCART
: POA-CA-COMPVGA
: KA-MC-DB10
: POA-TC-WL2500

The Terminal Panel Replacement

Fig. 1
Fig. 2
Fig. 3
Terminal Panel
Five(5) screws
Terminal Cover Attachment
Two(2) screws
Terminal Cover