Sanyo PLC-WL2503 Owner's Manual page 54

Setting
Lamp control
This function allows you to change brightness of the screen.
Normal ...... Normal brightness.
Eco . .......... Lower brightness reduces the lamp power
consumption and extends the lamp life.
Remote control
This projector provides two different remote control codes:
the factory-set initial code (Code 1) and the secondary code
(Code 2). This switching function prevents remote control
interference when operating several projectors or video
equipment at the same time.
When operating the projector in Code 2, both the projector
and the remote control must be switched to Code 2.
To change the code for the projector:
Select either Code 1 or Code 2 in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the code,
make sure the remote control operates properly.
Note:
• When different codes are set on the projector and on the
remote control, any operation can not be made. In that
case, switch the code on the remote control to fit the code
on the projector.
• If the batteries are removed from the remote control for a
long period of time, the remote control code will be reset.
54
Remote control