Remote Control Battery Installation; Attaching The Lens Cover - Sanyo PLC-SW30 Owner's Manual

Preparation

Remote Control Battery Installation

Remove the battery
1
compartment lid.
To insure safe operation, please observe the following precautions :
– Use (2) AAA, SUM-4 or R03 type alkaline batteries.
– Replace two batteries at the same time.
– Do not use a new battery with a used battery.
– Avoid contact with water or liquid.
– Do not expose the remote control to moisture, or heat.
– Do not drop the remote control.
– If a battery has leaked on remote control, carefully wipe case clean and install new batteries.
– Risk of explosion if battery is replaced by an incorrect type.
– Dispose of used batteries according to the instructions.

Attaching the Lens Cover

Thread the string through the hole on the lens
1
cover and then tie a knot in the string to secure it
in place.
14
Downloaded From projector-manual.com Sanyo Manuals
Slide the batteries into
2
the compartment.
Pull up and remove
the lid.
3
Two AAA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
Thread the other end of the string through the
2
hole at the bottom of the projector. Then pass the
lens cover through the resulting loop of the string.
Tie a knot in the string to secure it in place.
Replace the compartment
lid.