Speaker - HP xw3400 - Workstation Technical Reference Manual

Speaker

Prepare the workstation for disassembly
1.
Remove the access panel and rotate the workstation so the system board is parallel to the table to
2.
make it easier to work on
Remove the hard drive cables from the plastic shroud at the front of the chassis and from the hard
3.
drives.
Remove the shroud from the chassis
4.
Disconnect the speaker wire from the system board connector.
5.
Remove the two screws (1) that secure the speaker to the chassis.
6.
Remove the speaker by lifting it up (2) and out of the retaining clips.
7.
To install the speaker, reverse the removal procedures making sure that the speaker wire is at the upper
left of the speaker when viewed from inside the chassis.
ENWW
(Preparation for disassembly on page
(Access panel on page
(Fan shroud on page
61).
84).
59).
Speaker 89