HP xw3400 - Workstation Technical Reference Manual page 98
Hp xw3400 workstation - service and technical reference guide
Hide thumbs
Also See for xw3400 - Workstation:
- Installation manual (10 pages) ,
- Quick reference card (2 pages) ,
- Declaration of conformity (1 page)
Table of Contents
Advertisement
Go to step 7.
5.
If using a new heatsink, remove the protective covering from the bottom of the heatsink and place it
6.
in position atop the processor.
Secure the heatsink to the system board and system board tray with the four captive screws and
7.
attach the heatsink control cable to the system board.
CAUTION:
X) to evenly seat the heatsink on the processor. This is especially important as the pins on the socket
are very fragile and any damage to them may require replacing the system board.
NOTE:
After installing a new processor onto the system board, always update the system ROM to ensure
that the latest version of the BIOS is being used on the workstation. The latest system BIOS can be found
on the Web at: http://h18000.www1.hp.com/support/files.
88
Chapter 7 Removal and replacement procedures
Heatsink retaining screws should be tightened in diagonally opposite pairs (as in an
ENWW
Advertisement
Table of Contents
