HP xw3400 - Workstation Technical Reference Manual page 154

Table D-11
Power LED flashes Red five times, once every second, followed by a two second pause, and the workstation
beeps five times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause
Memory is installed incorrectly or is bad.
Power LED flashes Red six times, once every second, followed by a two second pause, and the workstation
beeps six times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause
Graphics card is not seated properly or is bad, or system board
is bad.
Power LED flashes Red ten times, once every second, followed by a two second pause, and the workstation
beeps ten times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause
Bad option card.
144 Appendix D Troubleshooting without diagnostics
Solving Hardware Installation Problems (continued)
Solution
CAUTION: To avoid damage to the DIMMs or the system
board, you must unplug the workstation power cord before
attempting to reseat, install, or remove a DIMM module.
Reseat DIMMs. Power on the system.
1.
Replace DIMMs one at a time to isolate the faulty module.
2.
Replace third-party memory with HP memory.
3.
Replace the system board.
4.
Solution
For systems with a graphics card:
Reseat the graphics card. Power on the system.
1.
Replace the graphics card.
2.
Replace the system board.
3.
For systems with integrated graphics, replace the system board.
Solution
Check each option card by removing the cards one at time
1.
(if multiple cards), then power on the system to see if fault
goes away.
Once bad card is identified, remove and replace bad
2.
option card.
Replace the system board.
3.
ENWW