Type 1 Battery Holder; Type 2 Battery Holder - HP xw3400 - Workstation Technical Reference Manual

Type 1 Battery Holder

Lift the battery out of its holder.
1.
Slide the replacement battery into position, positive side up.
2.
The battery holder automatically secures the battery in the proper position.
3.
Replace the workstation access panel
4.
Plug in the workstation and turn on power to the workstation.
5.
Reset the date and time, your passwords, and any special system setups, using Computer Setup.
6.
Refer to Section 2.2.

Type 2 Battery Holder

To release the battery from its holder, squeeze the metal clamp that extends above one edge of the
1.
battery. When the battery pops up, lift it out (1).
To insert the new battery, slide one edge of the replacement battery under the holder's lip with the
2.
positive side up (2). Push the other edge down until the clamp snaps over the other edge of the
battery.
Replace the workstation cover or access panel
3.
ENWW
(Access panel on page
(Access panel on page
61).
61).
Battery 93