HP xw3400 - Workstation Technical Reference Manual page 146

Table D-6 Solving Display Problems (continued)
Blurry video or requested resolution cannot be set.
Cause
If the graphics controller was upgraded, the correct graphics
drivers may not be loaded.
Monitor is not capable of displaying requested resolution.
Graphics card is bad.
The picture is broken up, rolls, jitters, or flashes.
Cause
The monitor connections may be incomplete or the monitor may
be incorrectly adjusted.
Monitor needs to be degaussed.
Image is not centered.
Cause
Position may need adjustment.
"No Connection, Check Signal Cable" displays on screen.
Cause
Monitor video cable is disconnected.
"Out of Range" displays on screen.
Cause
Video resolution and refresh rate are set higher than what the
monitor supports.
136 Appendix D Troubleshooting without diagnostics
Solution
Install the video drivers included in the upgrade kit.
Change requested resolution.
Replace the graphics card.
Solution
Be sure the monitor cable is securely connected to the
1.
workstation.
In a two-monitor system or if another monitor is in close
2.
proximity, be sure the monitors are not interfering with
each other's electromagnetic field by moving them apart.
Fluorescent lights or fans may be too close to the monitor.
3.
Degauss the monitor. Refer to the documentation that came with
the monitor for instructions.
Solution
Press the Menu button to access the OSD menu. Select
ImageControl/ Horizontal Position or Vertical
Position to adjust the horizontal or vertical position of the
image.
Solution
Connect the video cable between the monitor and workstation.
CAUTION: Ensure that the workstation power is off while
connecting the video cable.
Solution
Restart the workstation and enter Safe Mode. Change the
settings to a supported setting then restart the workstation so that
the new settings take effect.
ENWW