Installing The Enclosure Into The Rack - HP BladeSystem bc2000 - Blade PC Setup And Installation Manual

Installing the Enclosure into the Rack

The enclosure ships with two different sizes of thumbscrews:
●
Size 10-32 thumbscrews with white hexagonal washers, which are compatible with Compaq-
branded racks and some HP and third-party racks
●
Size M6 thumbscrews with black hexagonal washers, which are compatible with some third-party
racks that require metric sizes
To replace a thumbscrew:
1. Pull the thumbscrew outward (1).
2. Unscrew the thumbscrew (2) while holding on to the hexagonal washer.
3. Remove the thumbscrew and hexagonal washer (3).
4. Place the hexagonal washer at the back of the hole in the enclosure (1).
5. Insert the screw through the hole in the enclosure.
6. Press the head of the screw inward so that the spring is completely compressed (2).
ENWW Installing the Enclosure into the Rack 21