Post Error Messages - HP BladeSystem bc2000 - Blade PC Setup And Installation Manual

C

POST Error Messages

Use POST error messages to assist in troubleshooting and performing basic diagnostic functions. POST
error messages represent what the BIOS reports. The following table lists the numeric codes and text
messages specific to blade PCs.
For information about troubleshooting, see
NOTE: Attempt the recommended actions in the order in which they are listed. If the first does not
resolve the issue, try the next on the list.
POST Error Messages
Code/Message
101-Option ROM Checksum
Error
102/103-System Board Failure
162-System Options Not Set
163-Time & Date Not Set
164-Memory Size Error
201-Memory Error
ENWW
Troubleshooting on page
Health LED Possible Cause
Red Blade system board
has failed.
Red Blade PC system
board has failed.
Amber CMOS was cleared or
the blade PC's battery
has failed.
Amber CMOS was cleared
Amber Memory configuration
is incorrect.
Red An SODIMM may not
be seated correctly or
is bad.
62.
Recommended Action
● Clear CMOS.
●
Flash the system ROM.
●
Replace the blade PC.
●
Clear CMOS
●
Replace the blade PC.
●
Reset the system time and date in Computer
Setup (F10).
●
Replace the blade PC's RTC battery.
Reset the system time and date in Computer
Setup (F10).
●
Ensure the SODIMM(s) are properly
installed.
●
Verify that the proper type of SODIMM is
installed.
●
Reseat the SODIMM(s).
●
Replace the SODIMM(s).
●
Replace the blade PC.
●
Ensure the SODIMM(s) are properly
installed.
● Verify that the proper type of SODIMM is
installed.
● Reseat the SODIMM(s).
57