Restoring The Configuration Settings - HP BladeSystem bc2000 - Blade PC Setup And Installation Manual

Table 5-6 Computer Setup—Advanced (for advanced users) (continued)
PCI Devices
Device Options

Restoring the Configuration Settings

Restoring the configuration settings requires that you first perform the Save To Removable Media
command within the Computer Setup (F10) Utility before Restore is needed.
NOTE: It is recommended that you save any modified computer configuration settings to removable
media, and save the removable media for possible future use.
To restore the configuration, insert the removable media with the saved configuration into a USB drive
(attached via the diagnostic adapter) and perform the Restore from Removable Media command with
the Computer Setup (F10) Utility.
42 Chapter 5 Deployment and Management
● Lists currently installed PCI devices and their IRQ settings.
●
Allows you to reconfigure IRQ settings for these devices or to disable them entirely. These
settings have no effect under an APIC-based operating system.
Allows you to set:
●
Num Lock state at power-on (off/on).
● S5 Wake on LAN (enable/disable).
◦
To disable Wake on LAN during the off state (S5), use the arrow (left and right) keys to
select the Advanced > Device Options menu and set the S5 Wake on LAN feature to
Disable. This obtains the lowest power consumption available on the computer during S5.
It does not affect the ability of the computer to Wake on LAN from suspend or hibernation,
but will prevent it from waking from S5 via the network. It does not affect operation of the
network connection while the computer is on.
◦
If a network connection is not required, completely disable the network controller (NIC) by
using the arrow (left and right) keys to select the Security > Device Security menu. Set
the Network Controller option to Device Hidden. This prevents the network controller from
being used by the operating system and reduces the power used by the computer in S5.
●
Processor cache (enable/disable).
● Integrated video (enable/disable)
●
Integrated Graphics Memory Size
● Integrated Graphics Engine Clock (dynamic/static)
●
NIC PXE Option ROM Download (enable/disable). The BIOS contains an embedded NIC option
ROM to allow the unit to boot through the network to a PXE server. This is typically used to
download a corporate image to a hard drive. The NIC option ROM takes up memory space
below 1MB commonly referred to as DOS Compatibility Hole (DCH) space. This space is
limited. This F10 option will allow users to disable the downloading of this embedded NIC option
ROM thus giving more DCH space for additional PCI cards which may need option ROM space.
The default will be to have the NIC option-ROM-enabled.
●
HPET (enable/disable). Enable/disable the High Precision Event Timer (HPET) for operating
system use.
●
Synchronize Time with Enclosure (enable/disable)
● USB 2.0 Capability (automatic, enable/disable)
●
Automated System Recovery (enable/disable). Enable/disable the ASR feature, which allows
you to recover from system lockup.
ENWW