Feed Unit - Kyocera FS-C8500DN Operation Manual

Message
Cannot staple
this Paper.
Cannot punch
this Paper.
Cannot offset
this Paper.
Set the paper

feed unit.

Replace the toner.
Newly added jobs are
printed in B & W.
Check waste toner
box.
Finisher tray #
is full of Paper.
6-12
Corrective Action
Stapling is not possible because a paper size that cannot be stapled is selected.
To print without stapling, press [OK].
Punching is not possible because a paper size that cannot be punched is
selected. To print without punching, press [OK].
Offsetting is not possible because a paper size that cannot be offset is selected.
To print without offsetting, press [OK].
The paper feed unit is not correctly installed. Pull out paper cassette 1. Pull out
the paper feed unit and then push it firmly back in.
Replace the color (cyan, magenta, yellow) toner container. Until the container is
replaced, printing will take place in black and white mode. For details, refer to
ColorToner Empty (Setting when color toner runs out) on page 4-80.
The waste toner box is almost full. Replace the waste toner box. For details, refer
to Replacing the Waste Toner Box on page 5-6.
The waste toner box is not installed. Install the waste toner box. For details, refer
to Replacing the Waste Toner Box on page 5-6.
Tray # of the optional 3,000 Sheet Document Finisher has become full. When the
printer detects that tray # is empty again, the printer will continue printing into tray
#.
Troubleshooting