Kyocera FS-C8500DN Operation Manual page 138

Sleep Timer:
(1 - 240)
/15-min.
PanelReset Timer: a b
(5 - 495)
/90-sec.
4-82
3
4
Sleep Timer (Sleep timer timeout time)
If Auto Sleep is set to On, you can adjust the length of time the printer
waits before entering Auto Sleep in the absence of data. The printer
reverts to normal operation mode when the printer receives a print job,
[OK] is pressed or one of the exterior covers is opened. The default time
is 15 minutes.
1
2
a b
M
3
4
PanelReset Timer (Setting the panel reset timer)
When Auto Panel Reset is set to On, this sets the time until the panel
is automatically reset after the user stops using the panel.
The default setting is 90 seconds.
1
2
M
3
Use the arrow keys to set the recovery time.
Press or to increase or decrease, respectively, the value at the
blinking cursor.
Use and to move the cursor right and left.
Press [OK]. The recovery time setting is stored and the Timer Setting
menu reappears.
Note Color calibration is automatically executed before the
printer reverts to normal operation mode.
In the Timer Setting menu, press
Press [OK]. The Sleep Timer screen appears.
Use the arrow keys to set the sleep time.
Press or to increase or decrease, respectively, the value at the
blinking cursor.
Use and to move the cursor right and left.
Press [OK]. The sleep time setting is stored and the Timer Setting
menu reappears.
In the Timer Setting menu, press
Timer.
Press [OK]. The PanelReset Timer screen appears.
Use the arrow keys to set the panel reset time.
Press or to increase or decrease, respectively, the value at the
blinking cursor.
Use and to move the cursor right and left.
or to select Sleep Timer.
or to select PanelReset
Using the Operation Panel