Connecting Two Pcs To The Monitor - Eizo RADIFORCE RX211 User Manual

-. Connecting Two PCs to the Monitor

Two PCs can be connected to the monitor through the Signal 1 and the Signal 2 on the
back of the monitor.
Selecting the Active Input
The Input Signal Selection Switch on the control panel can be used to select either Signal 1
or Signal 2 as the active input at any time. Every time the Switch is touched, the input
changes. When the signal is switched, the active signal type (Signal 1 or 2/ Analog or
Digital) appears at the top right corner of the screen.
The Priority Input Signal
This function is used to select which PC will have priority to control the monitor by
selecting <Input Priority> in the ScreenManager <Setup> menu (See p. 23 to use the
ScreenManager). In the case of only one signal being present at either input, the monitor
automatically detects and displays that signal.
Priority Setting
1
(DVI-D Connector)
2
(D-Sub mini 15 pin Connector)
Manual
Tips
• When the "1" or "2" is selected, the power saving mode of the monitor activates only if
both PCs are in power saving mode.
Input Signal Selection Switch
SIGNAL1
DVI-D
The monitor gives preference to Signal 2 in the following cases.·
• When the power of the monitor is turned ON
• When the signal input to Signal 1 is changed even if active input
was Signal 2
The monitor gives preference to Signal 2 in the following cases.·
• When the power of the monitor is turned ON
• When the signal input to Signal 2 is changed even if active input
was Signal 1
The monitor will not detect signals automatically in this mode.
Select the active input by pressing the Input Signal Selection
Switch on the monitor's control panel.
2. Cable Connection and Screen Adjustment
Performance
SIGNAL2
D-Sub mini 15
1