Troubleshooting - Eizo RADIFORCE RX211 User Manual

7. Troubleshooting

. Troubleshooting
If a problem persists even after applying the suggested remedies, contact an EIZO dealer.
• No picture problems
• Imaging problems
• Other problems
• USB problems See No.21
Problems
1. No picture
Indicator status: Off
Indicator status: Orange
Indicator status: Green
Indicator status: Flashing orange slowly
Indicator status: Flashing orange quickly
2. The message below appears.
• The message appears when the signal is not
input. (This is displayed for about 40 seconds)

See No.1 ~ No.2
See No.3 ~ No.14
See No.15~ No.20
Points to check with possible solutions
• Check that the power cord is connected correctly.
If the problem persists, turn off the monitor power
for a few minutes, then turn it back on and try
again.
• Try touching the power switch to turn it on again.
• Switch the signal input by touching the Input
Signal Selection switch on the front control panel.
• Try pressing a key on the keyboard or clicking the
mouse (p. 25).
• Try turning the PC on.
• Set each RGB adjusting value in <Gain> to higher
level. (p. 30).
• Try touching the power switch to turn it on again.
• Try touching the power switch to turn it on again.
• If the power switch turns off again (indicator
status: flashing orange quickly) within one minute
of turning on, refer to Problem No. 20 on p. 39
These messages appear when the signal is not
inputted correctly, even if the monitor functions
properly.
• The message might appear because some PCs
do not output the video signal immediately after
powering on. If the image is displayed correctly
after a short time, there is no problem with the
monitor.
• Check that the PC is turned on.
• Check whether the signal cable is connected
properly.
• Switch the signal input by pressing the Input
Signal Selection Switch on the front control panel.