Oki ML620 User Manual page 65

MENU SETTINGS TABLE
Group Item
Serial I/F Baud Rate
(cont.)
DSR Signal
DTR Signal
Busy Time
Stop Bit
Receive Error
Function
Set this to match your system's
transmission speed.
Used with the Ready/Busy
protocol (factory default) to select
the way your system handles the
DSR signal.
Change to Ready on Select if the
DTR signal is required when the
printer is selected (leave as Ready
on Power Up if the DTR signal
is required when the printer is
turned on).
Sets the length of the busy signal
when the Ready/Busy protocol
(factory default) is engaged,
Set the stop bit length.
When "checked" is selected the
printer checks for the correct
number of bits and sends an error
if an incorrect number is found.
Settings (defaults are set in bold italic)
19200 bps, 9600 bps, 4800 bps,
2400 bps, 1200 bps, 600 bps, 300
bps
Valid, Invalid
Ready on Power Up, Ready on
Select
0.2 sec, 1 sec
1 bit, 2 bit
Checked, Unchecked
ML620/ML621 User's Guide