Panasonic WJNT304 - NETWORK INTERFACE UNIT Network Operating Instructions page 57

Symptom
Cannot receive audio from
the unit./Cannot transmit
audio to the unit.
The mic input button and the
audio output button on the
"Live" page do not display
the current status in real
time.
Cause/solution
• Are the microphone and the speaker connected cor-
rectly and firmly?
Confirm that they are connected correctly and firmly.
• Is the viewer software installed on a PC?
Confirm that the viewer software "Network Camera
View3" is installed.
Is the audio mode set correctly?
• To receive and transmit audio, select "Interactive" for
"Audio mode" on the [Audio] tab.
• Are you accessing with the access level that can
receive and transmit audio?
• Access with the access level selected for
"Authentication" on the [Audio] tab.
• Is the viewer software installed on a PC?
Confirm that the viewer software "Network Camera
View3" is installed.
• Does your PC meet the system requirements to oper-
ate this unit?
Check the system requirements.
• Are the mic input button and audio output buttons set
to display the current status in real time?
Select "Real time" for "Alarm status update mode" on
the [Basic] tab of the "Basic setup" page.
Reference
pages
Operating
Instructions
Operating
Instructions
29
Operating
Instructions
Operating
Instructions
19
57