Panasonic WJNT304 - NETWORK INTERFACE UNIT Network Operating Instructions page 21

Configure the settings relating to SD memory card [SD memory card]
Click the [SD memory card] tab on the "Basic setup" page. ( page 18)
The settings relating to the SD memory card can be configured on this page.
I SD memory card setup
[SD memory card]
Select "Use" or "Not use" to determine whether or not to
use the SD memory card.
Default setting: Not use
Important:
• When the power is shut down while saving images
on the SD memory card because of power failure,
etc., SD memory card or the contents of card may
be destroyed.
(When using an SD memory card, it is recommend-
ed to use an UPS (uninterruptible power equip-
ment).)
• Before removing the SD memory card from the unit,
it is necessary to select "Not use" first.
• Before inserting a SD memory card into the SD
memory card slot, turn the power of the unit off. (
Operating Instructions) After inserting the SD memo-
ry card, it is necessary to select "Use" to use the SD
memory card.
[Notification of remaining]
When the "Panasonic alarm protocol" function is used to
provide notification of the remaining space of the SD
memory card, select a level to be notified at from the fol-
lowing.
50 %/20 %/10 %/5 %/2 %
Default setting: 50 %
Note:
Notification will be provided when the remaining
space of the SD memory card reached the values
above.
For example, notification will be provided for the
destination IP address when the remaining space
reaches 50 % or less when "50%" is selected. (
page 36)
Notification may not always be made at the very
moment when the remaining space of the SD mem-
ory card has reached each value.
I Information about SD memory card
[SD memory card]
Available size and the total size of the SD memory card
will be displayed.
Depending on the state of the SD memory card, the size
indications will differ as follows.
Content
----------KB/-----------KB
**********KB/**********KB The SD card memory is
Note:
When the available size reached "0 KB", images will
not be saved on the SD memory card.
When the notification function is on, a notification
mail will be sent to the registered addresses when
the SD memory card becomes full. ( page 36)
[Format]
To format the SD memory card, click the [Execute] but-
ton.
Description
No SD memory card is
inserted.
Failed to obtain available
size due to error, etc.
unformatted, or locked, etc.
21