Panasonic WJNT304 - NETWORK INTERFACE UNIT Network Operating Instructions page 28

Configure the settings relating to camera [Camera]
Click the [Camera] tab on the "Camera setup" page. ( page 24)
The following are descriptions of how to display the setup menu and configure the settings relating to camera opera-
tion using the operation panel. Refer to the provided operating instructions for further information about emergency
recording.
About the operation panel
Use the following buttons on the operation panel to operate the "Camera setup" page using a PC.
[ON] button: Click this button to display the top
page of the "Camera setup" page.
[OFF] button: Click this button to close the
"Camera setup" page.
[SET] button: Click this button to move to the
submenu.
[Left] button/
these button to select the parameters.
[Down] button/
these buttons to move the cursor.
28
[Right] button: Click
[Up] button: Click
[CH No.]
Select a channel to configure the setting.
ZOOM buttons, FOCUS buttons, Control
pad/buttons
Select a channel to configure the setting relating to the
camera operation.
Refer to pages 5 and 6 for further information.
[ESC] button: Click this button to return
to the previous page.
[RESET/SPECIAL] button: Display the
SETUP MENU of camera, move the cursor onto
SPECIAL, and click this button to move to the SPE-
CIAL SETUP menu.
Move the cursor onto REFRESH on the SPECIAL
SETUP menu, and click this button to refresh the
camera position.
For further information, refer to the operating instruc-
tions of the camera.
[ALL RESET] button: Click this button
after moving the cursor onto CAMERA RESET on
the SPECIAL SETUP menu to reset to the default
setting. Refer to the operating instructions of each
camera for further information about the settings to
be reset.