Panasonic WJNT304 - NETWORK INTERFACE UNIT Network Operating Instructions page 45

Configure the settings relating to SNMP [SNMP]
Click the [SNMP] tab on the "Network setup" page. ( page 41)
The settings relating to SNMP can be configured on this page. It is possible to check the status of the unit by con-
necting to the SNMP manager. When using the SNMP function, contact the network administrator.
[Community name]
Enter the community name to be monitored.
Number of characters that can be entered: 0 - 32
characters
Default setting: (blank)
Important:
When using the SNMP function, it is necessary to
enter the community name. When no community
name is entered, the SNMP function will not work.
[Unit title]
Enter a unit title to be used to manage the unit with the
SNMP function.
Number of characters that can be entered: 0 - 32
characters
Default setting: (blank)
[Unit location]
Enter the name of the location where the unit is
installed.
Number of characters that can be entered: 0 - 32
characters
Default setting: (blank)
[Contact (Destination address or phone number of
manager)]
Enter the mail address or the phone number of the
SNMP manager.
Number of characters that can be entered: 0 - 255
characters
Default setting: (blank)
Notes:
• "" is regarded as a blank.
• It may take around 30 seconds until the setting is
applied.
45