Table of Contents
Advertisement
To see the time display :
Press the CLOCK button.
•
The time display will appear for about 5 seconds.
Note :
• The clock display will flash on and off at the push
of the CLOCK button when the AC power sup-
ply is restored after a power failure occurs or
after the AC power cord is disconnected. If this
happens, follow the procedure to change the
clock time.
CHANNEL SPACE SETTING
The space between radio channels has been set to the one that prevails in the area to which the system
is shipped. However, if the current channel space setting does not match the setting in the area where
the system is to be used, for instance when you move from area 1 or area 2 shown in the following table
or vice versa, proper reception of AM/FM broadcasts cannot be expected. In this case, change the chan-
nel space setting in accordance with your area by refering to the following table.
Area
1 USA, Canada and Latin
America Countries
2 Other countries
1
Press the
the standby mode.
2
Set the SPAN SELECTOR switch to "50/9" for
9 kHz AM interval (50 kHz FM interval), and "100/
10" for 10 kHz AM interval (100 kHz FM inter-
val).
3
Whilst pressing down the 7 STOP button and
the SOUND MODE button, hold down the
ON/STANDBY button for at least 1 second.
•
"CLEAR AL " will appear.
12
EN
CHANNEL
SPACE freq.
FM : 100 kHz
AM :
10 kHz
FM : 50 kHz
AM :
9 kHz
ON/STANDBY button to enter
To change the clock time :
1 Press the CLOCK button.
2 Within 5 seconds, press the MEMORY/SET but-
ton.
6
3 Perform steps
To change the time display mode :
1
1 Perform steps
TING THE MICROCOMPUTER" , on page 47 .
2
2 Perform step
-
Caution :
•
This operation will erase all data stored in
memory including clock and timer settings, and
tuner and CD presets.
9
-
on page 11 .
2
-
in the section "RESET-
9
on page 11.
Hide quick links:
Advertisement
Table of Contents
