SETTING THE CLOCK
ON/
STANDBY
CLOCK
TUNING/TIME
(fi %)
2
3
4
5
6
7
8
9
In this example, the clock is set for the 24 hours
(0:00) system.
1
CLOCK
MEMORY
/SET
2
TUNING/
TIME (%UP
3
fiDOWN)
4
POWER
MEMORY
/SET
•
5
6
•
•
7
8
•
•
9
•
Press the
ON/STANDBY button to enter
the standby mode.
Press the CLOCK button.
Within 5 seconds, press the MEMORY/SET
button.
Press the TUNING/TIME (%UP or fiDOWN)
button to select the time display mode.
"0:00"
: The 24-hours display will appear.
(0:00 - 23:59)
"AM 0:00" : The 12-hours display will appear.
(AM 0:00 - PM 11:59)
"AM 12:00" : The 12-hours display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is
first installed or it has been reset (see page 47
- RESETTING THE MICROCOMPUTER).
Press the MEMORY/SET button.
Press the TUNING/TIME (%UP or fiDOWN)
button to adjust the hour.
Press the TUNING/TIME (%UP or fiDOWN)
button once to advance the time by 1 hour.
Hold it down to advance continuously.
When the 12-hours display is selected, "AM"
will change automatically to "PM"
Press the MEMORY/SET button.
Press the TUNING/TIME (%UP or fiDOWN)
button to adjust the minutes.
Press the TUNING/TIME (%UP or fiDOWN)
button once to advance the time by 1 minute.
Hold it down to change the time in 5 minutes
intervals.
The hour setting will not advance even if min-
utes advance from "59" to "00" .
Press the MEMORY/SET button.
The clock starts operating from "0" second.
(Second are not displayed.)
And then the clock display will disappear after
a few seconds.
11
EN