Ring Settings; Fxo (Pstn) Timer Values (Sec) - Linksys SPA1001 Administrator User Manual

PSTN Line Tab
Field
VoIP User 1/2/3/4/5/6/7/8
Password
Field
VoIP User 1/2/3/4/5/6/7/8 Auth
ID
VoIP User 1/2/3/4/5/6/7/8 DP
VoIP User 1/2/3/4/5/6/7/8
Password

Ring Settings

Field
Default Ring

FXO (PSTN) Timer Values (sec)

Field
VoIP Answer Delay
Linksys IP Phone Administrator Guide
5-60
Description
The password to be used with VoIP User 1. The user assumes the identity of VoIP User 1
must therefore compute the credentials using this password, or the INVITE will be
challenged with a 401 response
The default is blank.
Description
The first of 8 user-id's that a VoIP Caller can use to authenticate itself to the SPA using
the HTTP Digest method (in other words, by embedding an Authorization header in the
SIP INVITE message sent to the SPA. If the credentials are missing or incorrect, the SPA
will challenge the caller with a 401 response). The VoIP caller whose authentication
user-id equals to this ID is referred to VoIP User 1 of this SPA.
Note: If the caller specifies an authentication user-id that does not match any of the VoIP
User Auth ID's, the INVITE will be rejected with a 403 response.
The default is blank.
Index of the dial plan in the dial plan pool to be used with VoIP User 1.
The default is 1.
The password to be used with VoIP User 1. The user assumes the identity of VoIP User 1
must therefore compute the credentials using this password, or the INVITE will be
challenged with a 401 response
The default is blank.
Description
1-8, Follow Line Cfg
Description
Delay in seconds before auto-answering inbound VoIP calls for the FXO account. The
range is 0-255.
The default is 3.
Chapter 5 Linksys ATA Field Reference
Document Version 3.2