User 1/2 Tab; Call Forward Settings - Linksys SPA1001 Administrator User Manual

Chapter 5 Linksys ATA Field Reference

User 1/2 Tab

This section describes the fields for the following headings on the User 1 and User 2 tabs:
•
•
•
•
•
•
User 1/2 refers to the subscriber of Line 1 or Line 2.
For the SPA8000, the settings on this page occur on each Line tab ([1] to [8]).
Note
When a call is made from Line 1 or Line 2, Linksys IP phone shall use the user and line settings for that
Line; there is no user login support in Linksys IP phone v1.0. Per user parameter tags must be appended
with [1] or [2] (corresponding to line 1 or 2) in the configuration profile. It is omitted below for
readability.
Note References in this section to the SPA3102 also apply to the AG310.

Call Forward Settings

Field
Cfwd All Dest
Cfwd Busy Dest
Document Version 3.2
Call Forward Settings, page 5-65
Selective Call Forward Settings, page 5-66
Speed Dial Settings, page 5-67
Supplementary Service Settings, page 5-67
Distinctive Ring Settings, page 5-68
Ring Settings, page 5-68
Description
Forward number for Call Forward All Service
In addition to normal call forward destination as used in the other ATAs, on the SPA3102,
you can specify the following additional parameters:
• gw0 – forward the caller to use the PSTN gateway
• <pstn-number>@gw0 – forward to caller to the PSTN number (dialed automatically
by the SPA through the PSTN gateway)
The default is blank.
Forward number for Call Forward Busy Service. Same as Cfwd All Dest.
The default is blank.
Linksys IP Phone Administrator Guide
User 1/2 Tab
5-65