Wrp400 - Linksys SPA1001 Administrator User Manual

Linksys Analog Telephone Adapters (ATAs)
Table 1-17 SPA8000 Back Panel
Port
AUX
Ethernet
Power

WRP400

The WRP400 provides an ATA with two FXS ports and a Wireless-G multiport IP router (see
Figure
to a LAN with a built-in four-port switch. The IP router provides QoS support, an integrated firewall and
VPN pass-through, and full routing with DHCP and NAT.
Figure 1-11 WRP400
Linksys ATA Administrator Guide
2-10
Function
Ethernet maintenance port. Connect to a network device, such as a PC or a
switch with an Ethernet cable for accessing the administration web server
on the SPA8000. The attached device is assigned an IP address dynamically
by the internal DHCP server provided by the SPA8000.
Connect to a switch, router or broadband (cable/DSL) modem for access to
the Internet.
Note
Connect to the 12-volt DC power adapter.
Caution
1-11). The WRP400 provides connectivity to an analog telephone as well as Internet connectivity
When connected directly to the Internet, connectivity between FXS
devices on the SPA8000 depends on the Outbound Proxy service
provided by the ITSP.
This 12-volt power adapter is to be used only with the SPA8000.
Using it with any other Linksys product may damage the unit.
Chapter 2 Getting Started
Document Version 3.1