Selecting A Group Dial Destination - Konica Minolta magicolor 1690MF User Manual

The information registered for the speed dial destination appears for two
seconds.
3
Press the Select key again.
If an FTP address or an SMB address was selected, the destination
address is specified.
4
If an e-mail address was selected, press the + or , key to select
, and then press the Select key.
ISH

Selecting a Group Dial Destination

A maximum of 20 group dial destinations can be registered on this machine.
(A maximum of 50 e-mail addresses can be registered with one group.) Fol-
low the procedure described below to specify e-mail addresses from the reg-
istered group dial destinations as the recipient of the scan data.
For details on registering e-mail addresses as group dial destinations,
refer to "Registering Group Dial Destinations" on page 6-24.
A group dial destination containing a telephone number cannot be
used in Scan mode.
1
With the main screen (Scan mode) or
played, press the AddressBook key three times so that
appears.
2
Use the keypad to type in the number (between 1 and 20) for the group
dial destination, and then press the Select key.
The information registered for the group dial destination appears for two
seconds.
3
Press the Select key again.
4
Press the + or , key to select
6-14
To add an additional e-mail address, select
then specify the destination. When sending the data to an FTP
address or SMB address, multiple addresses cannot be specified.
To check the specified e-mail address, select
step 4. To delete an address, select
then continue with step 2 of "Deleting a Specified Destination
Address".
To add an additional e-mail address, select
then specify the destination.
To check the specified e-mail address, select
step 4. To delete an address, select
then continue with step 2 of "Deleting a Specified Destination
Address".
CHECK
Can Use AddressBook
, and then press the Select key.
FINISH
CHECK
Scanning With the Machine
FIN-
in step 4, and
ADD
/ in
CHECK EDIT
/ in step 4, and
EDIT
dis-
GROUP DIAL
in step 4, and
ADD
/ in
CHECK EDIT
/ in step 4, and
EDIT