Iscsi Virtual Target Configuration; Automatic Iscsi Vt Creation; Generating Iscsi Vts For Every Fc Target - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

Reply from 30.0.0.1: bytes=64 rtt=0ms ttl=255
Reply from 30.0.0.1: bytes=64 rtt=0ms ttl=255
Reply from 30.0.0.1: bytes=64 rtt=0ms ttl=255
Reply from 30.0.0.1: bytes=64 rtt=0ms ttl=255
Ping Statistics for 30.0.0.1:
Packets: Sent = 4, Received = 4, Loss = 0 ( 0 percent loss)
Min RTT = 0ms, Max RTT = 0ms Average = 0ms
7. Optional: Enter the portCfg arp command to configure additional ARP entries.
switch:admin> portcfg arp 3/ge0 add 30.0.30.11 00:0F:1F:69:99:88
Operation Succeeded
8. Optional: Verify the entry using the portShow command.
switch:admin> portshow arp 3/ge0
Slot: 3 Port: ge0
IP AddressMac AddressFlags
-----------------------------------------------------------
30.0.30.214
30.0.0.1
30.0.30.11

iSCSI Virtual Target Configuration

Configuring an iSCSI environment involves creating iSCSI virtual targets (VTs), discovery domains (DDs),
discovery domain sets (DDSets), and defining iSCSI VT-iSCSI initiator authentication.
NOTE: You can also configure iSCSI virtual targets through the Web Tools Graphical User Interface as an
alternative to the command line interface. See the Web Tools Administrator's Guide for descriptions of
GUI-based configuration procedures.
You create iSCSI VTs using the LUN values of FC targets. The FC target must be accessible from the iSCSI
gateway. iSCSI VTs can be automatically generated or manually created.
After mapping iSCSI targets do not move the targets out of Administrative Domain 0 (AD0), unless you
then explicitly add them back to AD0.

Automatic iSCSI VT creation

An iSCSI VT is created using target LUNs from the attached FC network. LUNs are mapped to iSCSI VTs by
creating unique iSCSI Qualified Names (IQNs) for each target.
You can create iSCSI VTs by using the iscsiCfg
options:
• An iSCSI VT may be created for every FC target. IQNs are created automatically, using the port
WWNs as the user defined portion of the IQN.
• A port WWN may be specified to create one ISCSI VT with all LUNs for that FC target. The WWN of
the FC target is used as the user defined portion of the IQN.

Generating iSCSI VTs for every FC target

1. Connect and log in to the switch.
2. Enter the iscsiCfg
The command returns a prompt indicating that this could be a long running operation.
3. Enter y or yes to continue. IQNs are created. The default value of iqn.2002-12.com.brocade, is
used for the prefix unless it has been changed by using the iscsiSwCfg - -modifygw -t
<tgtname> command. The port WWN is used as the user-defined portion of the IQN.
The following is an example:
312 iSCSI gateway service
00:c0:dd:07:81:13 Resolved
00:11:93:58:fd:7f Resolved
00:0f:1f:69:99:88 Permanent Resolved
easycreate tgt command with no options.
--
easycreate tgt command. There are two
--