D Migrating From An Mp Router To A 400 Mp Router; Introduction To Mp Router Upgrades; Non-Redundant Configuration; Non-Redundant Router Configuration - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

D
Migrating from an MP Router to a 400 MP Router

Introduction to MP Router upgrades

This appendix describes how to upgrade routers in your fabric with the least disruption, while providing
better performance and scalability. Improper implementation could lead to a change in the xlate Domain
IDs and proxy device PIDs, which may cause disruption in the fabric.
FC routers are deployed in different configurations in a fabric. Those configurations are listed in the
following pages and steps have been provided to integrate the 400 MP Router in a fabric with the HP
StorageWorks Multi-Protocol Router. The figures in the following pages demonstrate how the 400 MP
Router should be integrated into a specified configuration, whether it is non-redundant, redundant, or in a
dual backbone configuration.

Non-redundant configuration

Figure 87 shows an example of a simple non-redundant configuration.
Figure 87

Non-redundant router configuration

A 400 MP Router can be inserted into an existing metaSAN so that the old and new configuration form
one redundant configuration. Before implementing this design, configure the new router's EX_Ports and
fabric IDs with the same configuration parameters. The new configuration will look like
Follow the steps in
be the same as on the old router, before it is introduced in the metaSAN.
.
Figure 88

Configuration during the upgrade

The switch Domain ID and backbone fabric ID of the new FC router can be identical. Once the metaSAN
is stable, EX_Ports on the new router are active, the old router can be taken out of the setup.
"To configure the new router:" on page 545 to change the configuration parameters to
Figure 88.
Fabric OS 6.2 administrator guide 543