Led Behavior - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

ICL1 <--> ICL1
ICL ports can be used only with an ICL license. For more information license enforcement, see
features" on page 43. After the addition or removal of a license, the license enforcement is performed on
the ICL ports only when you enter the portDisable or portEnable commands on the switch for the
ports. All ICL ports must be disabled, and then re-enabled for the license to take effect. An ICL license must
be installed on both platforms forming the ICL connection.
There are two LEDs (a status LED and an attention LED) for each ICL connector port.
behavior of the LEDs.
Table 72

LED behavior

LED Color
Status Black
Green
Attention
Black
Blinking Yellow
The ICL ports appear as regular ports, with some restrictions. All port parameters associated with ICL ports
are static and all portCfg commands are blocked from changing any of the ICL port parameters. The
only management associated with ICL ports and cables is monitoring the status of the LEDs on the ICL ports
and any maintenance if the ATTENTION LED is blinking yellow. For additional information about the LED
status for blades and ports, see the relevant hardware document.
When you connect two HP StorageWorks Backbones, the following features are supported:
• 8 Gb/s speed
• Trunking
• Credit sharing
• QoS
Description
No connection with peer blade
ICL connection with peer blade is
good.
ICL is fully operational.
One or more links in the ICL
connection is NOT operational.
"Licensed
Table 72 describes the
Action
N/A
N/A
N/A
Reconnect the ICL cables
or replace the ICL
cables.
Fabric OS 6.2 administrator guide 281