Configuration Download Without Disabling A Switch; Restoring A Configuration; Cli Commands To Display Or Modify Switch Configuration Information - HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual

In case something happens to your switch and you need to set it up again, run the commands listed in
Table 46 and save the output in a file format. Store the files in a safe place for emergency reference.
Table 46

CLI commands to display or modify switch configuration information

Command
configShow
fcLunQuery
fcrRouterPortCost
fcrXlateConfig
fosConfig
ipAddrShow
iscsiCfg
iscsiPortCfg
iscsiTargetName
isnscCfg
licenseShow
portCfgEXPort
portCfgVEXPort
CAUTION: The switch has no error checking and edited files may become corrupted and can lead to
switch failures.

Configuration download without disabling a switch

You can download configuration files to a switch while the switch is enabled; that is, you do not need to
disable the switch for changes in SNMP or Fabric Watch parameters. However, if there is any changed
parameter that does not belong to SNMP or Fabric Watch, you must disable the switch. When you use the
configDownload command, you are prompted to disable the switch only when necessary.
Configuration download without disabling a switch is independent of the hardware platform and
supported on all hardware platforms running Fabric OS 5.2.0 and later.
IMPORTANT:
already exist and with the same FIDs. It cannot be used to clone or repair the current switch because the
configDownload command cannot create Logical Switches if they do not exist.

Restoring a configuration

1. Verify that the FTP service is running on the server where the backup configuration file is located.
2. Connect to the switch and log in as admin.
3. If there are any changed parameters in the configuration file that do not belong to SNMP, Fabric
Watch, or ACL, disable the switch by entering the switchDisable command.
4. Enter the configDownload command.
The command becomes interactive and you are prompted for the required information.
168 Maintaining the switch configuration file
Displays
System configuration parameters and settings, and license information
A list of LUN IDs and LUNs for all accessible targets
FC Router route information
A translate (xlate) domain's domain ID for both EX_Port-attached fabric and
backbone fabric
Fabric OS features
The IP address
iSCSI entities
The iSCSI port parameters
The IQN prefix
The configuration state of the iSNS client operation
The license keys you have installed. Provides better detail than the license
information from the configShow command.
EX_Port configuration parameters
VEX_Port configuration parameters
In Fabric OS 6.2, the configuration download process can restore only Logical Switches that