Adding Trap Managers; Configuring Ip Information; Assigning Ip Information To The Switch-Overview - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

Chapter 3 Configuring Ethernet Switching

Adding Trap Managers

Step 1
Step 2
Step 3
Step 4

Configuring IP Information

Assigning IP Information to the Switch—Overview
OL-2031-02
A trap manager is a management station that receives and processes traps. When
you configure a trap manager, community strings for each member switch must
be unique. If a member switch has an assigned IP address, the management station
accesses the switch by using its assigned IP address.
By default, no trap manager is defined, and no traps are issued.
Beginning in privileged EXEC mode, follow these steps to add a trap manager and
community string:
Task
Enter global configuration mode.
Enter the trap manager IP address,
community string, and the traps to generate.
Return to privileged EXEC mode.
Verify that the information was entered
correctly by displaying the running
configuration.
This section describes how to assign IP information on the Catalyst 4224, and
contains the following topics:
Assigning IP Information to the Switch—Overview, page 3-11
•
Assigning IP Information to the Switch—Procedure, page 3-12
•
Removing an IP Address, page 3-13
•
Specifying a Domain Name and Configuring the DNS, page 3-13
•
You can use a BOOTP server to automatically assign IP information to the switch;
however, the BOOTP server must be set up in advance with a database of physical
MAC addresses and corresponding IP addresses, subnet masks, and default
Catalyst 4224 Access Gateway Switch Software Configuration Guide
Managing the Catalyst 4224 Access Gateway Switch
Command
config terminal
snmp-server host
172.2.128.263 traps1 snmp
vlan-membership
end
show running-config
3-11