Recommended Configurations
Interface Range Command Support
Switched Port Analyzer (SPAN)
Recommended Configurations
Catalyst 4224 Access Gateway Switch Software Configuration Guide
1-22
You can use the range command. The following sample configuration shows how
to configure the range command:
C4224_SF(config)# int range fas5/2 - 5
switchport access vlan 60
switchport voice vlan 160
Switched Port Analyzer (SPAN), also known as port monitoring, is supported for
up to two sessions. Spanning a VLAN is not supported. You can only span
selected interfaces. The following sample configuration shows a configuration for
setting a port monitor session with the range command:
C4224_SF(config)# monitor session 1 ?
destination
SPAN destination interface or VLAN
source
SPAN source interface or VLAN
This section contains the following topics:
No VTP or DTP Support, page 1-23
•
Creating a VLAN, page 1-23
•
Defining a VLAN on a Trunk Port, page 1-23
•
Trunking, page 1-24
•
Fractional PRI Configuration, page 1-24
•
No Ring Back Tone Generated, page 1-25
•
MTP Required on Cisco CallManager, page 1-26
•
H323-Gateway VOIP Bind SRCADDR Command, page 1-27
•
Port Fast Not Enabled on Trunk Ports, page 1-28
•
Priority Queuing on Frame Relay, page 1-28
•
Chapter 1
Product Overview
OL-2031-02