Switchport Voice Vlan; Syntax; Syntax Description - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

switchport voice vlan

switchport voice vlan

Syntax

Syntax Description

Catalyst 4224 Access Gateway Switch Software Configuration Guide
A-10
You can verify the previous command by entering the show interface interface-id
switchport command in privileged EXEC mode and examining information in
the Administrative Mode and Operational Mode rows.
Use the switchport voice vlan interface configuration command to configure the
voice VLAN on the port. Use the no form of this command to return the setting
to its default.
switchport voice vlan {vlan-id | dot1p | none | untagged}
no switchport voice vlan
vlan-id
VLAN used for voice traffic. Valid IDs are from 1 to 1001 (IDs 1002 to 4095 are
not supported on Catalyst 4224 switches).
Do not enter leading zeroes.
dot1p
The telephone uses priority tagging and uses an 802.1Q VLAN ID of 0.
none
The telephone is not instructed through the CLI about the voice VLAN.
The telephone uses the configuration from the telephone key pad.
untagged
The telephone does not tag frames. The switch port can be an access port or an
802.1Q trunk port.
Appendix A Command Reference for Voice VLAN
OL-2031-02