No Vtp Or Dtp Support; Creating A Vlan; Defining A Vlan On A Trunk Port - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

Chapter 1 Product Overview

No VTP or DTP Support

Creating a VLAN

Defining a VLAN on a Trunk Port

OL-2031-02
Maximum Number of VLAN and Multicast Groups, page 1-29
•
IP Multicast Support, page 1-29
•
Using the interface switchport access or switchport trunk VLAN commands
automatically creates a voice VLAN and data VLAN. If you require an additional
VLAN beyond the voice and data VLAN when connecting to another switch, you
must add it manually using the VLAN database command from the EXEC prompt.
The following sample configuration shows how to define a VLAN manually:
C4224(vlan)# vlan 10 name external_switch_Vlan10
VLAN 10 added:
Name: external_switch_Vlan10
C4224(vlan)#vlan 11 name external_switch_Vlan11
VLAN 11 added:
Name: external_switch_Vlan11
C4224(vlan)#exit
APPLY completed.
Exiting...
The following sample configuration shows how to define a VLAN on a trunk port.
C4224(config-if)# switchport trunk allowed vlan 10
C4224(config-if)# switchport trunk allowed vlan add 11
By default, the trunk interface accepts all VLANs created by the VLAN database.
Therefore, you should use the switchport trunk allowed command to delete
unwanted VLANs from the interface.
Catalyst 4224 Access Gateway Switch Software Configuration Guide
Recommended Configurations
1-23