Table of Contents
Advertisement
Configuring Voice Interfaces
When you start a Catalyst 4224, it automatically detects the voice network
modules and VICs that have been installed. The first time you use a
Catalyst 4224, you need to configure each voice port that you want to enable. If
you replace a card after you configure each port, the gateway will recognize the
new hardware component and use the previous configuration settings.
If you replace a module that was already configured, the gateway recognizes it and
brings up the interface in the existing configuration.
To configure the Catalyst 4224 to boot in a new configuration, perform the
following steps:
Connect a terminal or a PC running terminal emulation software to the console
Step 1
port on the Catalyst 4224. Refer to the Catalyst 4224 Access Gateway Switch
Hardware Installation Guide for instructions.
Power on the Catalyst 4224. If the current configuration is no longer valid, you
Step 2
see the following prompt within about one minute:
Would you like to enter the initial dialog? [yes/no]:
Enter no. You now enter the normal operating mode of the gateway.
Step 3
Note
After a few seconds, you see the user EXEC prompt (
Step 4
the password to enter privileged EXEC mode, as follows:
c4224> enable
Password: <password>
c4224# enable
Configuration changes can be made only in privileged EXEC mode. When you
enter privileged EXEC mode, the prompt changes to the host name followed by a
pound sign (#), such as
Enter the commands required to configure the VICs installed in the Catalyst 4224.
Step 5
When you finish configuring the voice interfaces, return to global configuration
Step 6
mode using the exit command and return to enable mode by pressing Ctrl-Z.
Catalyst 4224 Access Gateway Switch Software Configuration Guide
5-2
If the current configuration is valid, you automatically enter normal
operating mode.
c4224#
Chapter 5
.
Configuring the Voice Interfaces
). Enter enable and
c4224>
OL-2031-02
Advertisement
Table of Contents
Troubleshooting
